Available at short notice in RAL of your choice from non-binding stock
Design
- Permissible total weight 15,000 kg
- Hook system according to DIN 30722, part 1
- Basic support made of INP 180
- Base plate 5 mm, material S 355 JR
- Side panels 3 mm all around, material S 355 JR
- All sheets and profiles at least S 235 JR
- Floor/side wall transition slanted 170 x 170 mm x 45°
- All-round ribs made of UB 80 x 50 x 5 mm
- Rib spacing 750 mm (center-center)
- Ribs welded throughout on the sides
- Upper end profile, rubbing strips round tube 90x7
- Galvanized ladder and screwed to the front wall
- Bottom ribs reinforced with S-knots
- Flat iron as a support profile (between the floor ribs, on the floor and base support)
- Plan hooks attached all around approx. 300 mm from the top edge of the container
Rear side
- Pendulum flap swings at the top and bottom
- Sheet thickness 5 mm, material S 235 JR
- Flap 1000 mm high, upper pivot point offset
- Lower storage as a seamless transition
(ideal for driving over small devices)
- Flap with ramp
- Flap can be accessed with an axle load of 3.5 tons
- Central locking according to UVV, to be operated by hand
- Flap with spring relief on both sides
- Fixed corner stanchions
Note:
The angle of inclination for driving on the flap corresponds to the rules of the trade association!
Painting
- Container primed inside and out
- Additionally painted on the outside high-quality 2-component paint
- Painted in the RAL color of your choice
| Austattung | |||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
